-
Move the row handle from S-bend bar to a point where it is resting near upper
pulley.
Item Description Qty 1 Handle 1 2 S-Bend handle 1 3 Upper pulley 1 -
Remove bolt and washer securing S-bend bar to footplate using a 6 mm Allen
wrench.
Item Description Qty 1 S-bend bar 1 2 Washer 1 3 Bolt 1 -
Loosen bolt and nut securing top of S-bend bar using a 6 mm Allen wrench and 17mm open
end wrench.
Item Description Qty 1 Nut 1 2 Bolt 1 3 S-bend bar 1 -
Remove red outer cover ring from tank by hand.
Item Description Qty 1 Tank 1 2 Red outer cover ring 1 -
Remove twelve water tank bolts using a Phillips screwdriver.
Item Description Qty 1 Tank 1 2 Bolts 12 -
Remove tank cover by prying off of tank back using a flat head screwdriver. Place on
drop cloth to avoid scratches.
Warning: Pry tank cover off carefully, do not damage with flat head screwdriver.
Item Description Qty 1 Tank back 1 2 Tank cover 1 -
Loosen set screws on adjustment handle using a 4 mm Allen wrench and remove adjustment
handle from backing plate shaft.
Item Description Qty 1 Adjustment handle 1 2 Set screw 2 3 Backing plate shaft 1 4 Tank cover 1 -
Remove twelve bolts securing tank ring to tank cover using a Phillips
screwdriver.
Item Description Qty 1 Tank ring 1 2 Bolt 12 3 Tank cover 1 -
Stand water tank cover on side and remove backing plate by tapping shaft out with
rubber mallet.
Item Description Qty 1 Backing plate shaft 1 2 Tank cover 1 3 Tap here with rubber mallet 1 -
Remove and discard both O-rings on backing plate shaft.
Item Description Qty 1 O-ring 2 2 Backing plate shaft 1
Remove Upper Water Tank Cover
